TBS Crossfire binding and set-up with Frsky Taranis

In this short article I will go through the steps to bind and set-up your TBS Crossfire and Frsky Taranis. It’s quite simple and you should be done in a few seconds 🙂

Continue reading TBS Crossfire binding and set-up with Frsky Taranis

PID tuning in the Air – FPV miniquad

PID tuning is the more complicated and less understood task in the FPV racing community. Although stock, default, PID values give an OK flying characteristic, I strongly suggest putting the effort into understanding how to tuning works.

This post will not cover PID tuning, but HOW-TO tune your PIDs in the air, using your remote. This will help make the process much easier and faster!

Continue reading PID tuning in the Air – FPV miniquad

Flash X4R SB receiver with the new PPM and S.BUS Firmware

X4R SB comes with a stock firmware allowing s.bus only. We will flash X4R SB with a newer firmware which will allow us to use it either in s.bus, or PPM. On top of that, channels 2 and 3 on PPM mode will act as CH9 and CH10.

Continue reading Flash X4R SB receiver with the new PPM and S.BUS Firmware