In this short article I will go through the steps to bind and set-up your TBS Crossfire and Frsky Taranis. It’s quite simple and you should be done in a few seconds 🙂
Continue reading TBS Crossfire binding and set-up with Frsky Taranis
Tag: sbus
Naze32 receiver – PWM, PPM and Serial (S.Bus)
There are 3 options for connecting your Naze32 receiver. First is PWM, requires connecting a wire from your receiver to the naze32 for each channel, a total of 8 wires. Second is PPM, requires a receiver that supports PPM (like the FrSky D4R-II), and one single wire. Third is Serial (S.bus or satellite for example), requires a receiver that supports a serial signal (like the FrSky X4R-SB or a DSM satellite) and one single wire.
Continue reading Naze32 receiver – PWM, PPM and Serial (S.Bus)
Flash X4R SB receiver with the new PPM and S.BUS Firmware
X4R SB comes with a stock firmware allowing s.bus only. We will flash X4R SB with a newer firmware which will allow us to use it either in s.bus, or PPM. On top of that, channels 2 and 3 on PPM mode will act as CH9 and CH10.
Continue reading Flash X4R SB receiver with the new PPM and S.BUS Firmware