Tag: frsky

TBS Crossfire binding and set-up with Frsky Taranis

In this short article I will go through the steps to bind and set-up your TBS Crossfire and Frsky Taranis. It’s quite simple and you should be done in a few seconds 🙂

Continue reading TBS Crossfire binding and set-up with Frsky Taranis

Frsky Failsafe for X4R SB and D4R II Receivers

Failsafe should be set immediately after you finish building your miniquad. Failsafe will determine what stick position will be used when your receiver stops receiving information from the transmitter, or when the connection is lost. Setting up frsky failsafe is very straight forward and should take less than a second.

Continue reading Frsky Failsafe for X4R SB and D4R II Receivers

Flash X4R SB receiver with the new PPM and S.BUS Firmware

X4R SB comes with a stock firmware allowing s.bus only. We will flash X4R SB with a newer firmware which will allow us to use it either in s.bus, or PPM. On top of that, channels 2 and 3 on PPM mode will act as CH9 and CH10.

Continue reading Flash X4R SB receiver with the new PPM and S.BUS Firmware